濟南專業防水http://www.liveevil.cn/談到進行家庭防水施工時，管道處理是重點也是難點。如果之前沒有做好基層修補，松動后容易滲水，如果涂刷過厚，在還沒有完全表干的情況下，因熱脹冷縮系數的不同，引發干縮裂縫，嚴重時就會導致滲漏。

1、濟南專業防水談到應仔細查找滲漏位置，如果確定僅是管口部位，則將周邊的基面鑿開，使用管口灌漿料或堵漏網進行填充加固。再圍著管道滲水點周圍做一個半徑為20cm的基面區域，對基面進行處理，使基面達到干凈、平整、堅固，充分濕潤基面后涂刷柔韌型防水漿料。注意，單次涂刷不要太厚，不能超過1mm，多次涂刷時要等上一次的涂刷基本干固（剛好不粘手），總厚度不能超過2mm。
Jinan professional waterproof spoke carefully to find the leak location, only if it is determined that the nozzle area, then scuttling around the base, using a nozzle plugging slipping through the net or grout fill reinforcement. Again around the pipe around the seepage point doing a radius of 20cm base surface area of the base surface for processing, so that the base surface to reach a clean, smooth, strong, full wet base after brushing flexible waterproof slurry.Note that a single brush not too thick, not more than 1mm, repeatedly brushing time to wait for the last time to dry brushing basic (just not sticky), the total thickness of no more than 2mm.

2、濟南專業防水http://www.liveevil.cn/介紹專門針對管道口做閉水試驗檢查，在管道周圍圍成一個密封區域，盡可能提高試水高度，不得低于20cm，從樓下觀察管道是否有水滲出，如果沒有，則管道滲水處理成功。如果是出現多處滲漏，或是難以確定漏水的位置，建議把整個衛生間的瓷磚打掉，做好管口錨固后重新進行全面的防水處理。
Jinan professional waterproof introduce specialize mouth closed water test for pipeline inspection, around the pipe surrounded by a sealing area, improve test the water height as possible, not less than 20cm, from downstairs to observe

whether there is water leaking pipes, and if not, pipeline seepage treatment success. If the emergence of multiple leaks, or is difficult to determine the location of leaks, it is recommended to knock down the entire bathroom tiles and

do a full re-waterproofing treatment nozzle anchor.